• Novo
Gongju322 9/10mm de orifício de mão correto Bit Bit Woodworking SAW Cutter FORSTER DROCH DA MELHORIA

Gongju322 9/10mm de orifício de mão correto Bit Bit Woodworking SAW Cutter FORSTER DROCH DA MELHORIA

€ 15.83

Montante
Existente

Tem capacidade e durabilidade comprovadas 9/10x70mm maduro, ferramentas de madeira Fool Free drilling bit bit woodworking hole serra cortador. Ampla gama de aplicações, como materiais de construção de fábrica, lojas de lugar, entusiastas de carpintaria. O cortador de moagem de madeira é especialmente intencional para a máquina de gravura portátil e de mesa e não pode ser usada na máquina como perfuração elétrica, máquina de perfuração e assim por diante. Lâmina mais nítida e melhora a eficiência e a durabilidade do serviço. Marca : verwoodsdescription : Especificação : GRAY DO PRODUTO : Industrial Gradecorpóreo : Carbid EType : Drill Bit Diy Suprimentos : Woodworking Application : Corte a placa de madeira inteira, placa de densidade, compensado, placa ecológica. Para uma máquina de aparar de bancada, máquina de gravura portátil e assim por diante. Não brilhante, corte suave, sem rebarbas, sem rebarbas, sem escurecimento.

Mais dados

Product grade:
 Industrial grade
Corporeal:
 Carbide
Type:
Core Drill Bit
DIY Supplies:
Woodworking
Application:
Cutting whole wood board,density board,plywood,ecological board.
Sizing Shank Diameter Blade Total length:
Ф9x70R 10mm 9mm 70mm:
Ф10x70R 10mm 10MM 70mm:
Features:
Specially fain for bench trimming machine,portable engraving machine and so on.:
No shining,smooth cutting,no burrs,no burrs,no blackening.:
The blade is made of high quality hard alloy and has been carefully unintentional,developed and tested,which makes the:
Cutting tools can produce smooth surface for wood such as hardwood,softwood and synthetic board,but should avoid processing metal materials such as copper and iron as substantially as non-wood materials such as sand and stone.:
Make sure to use the clamping sleeve of appropriate size,because it is worn seriously,not round enough and with taper of inner bore cannot provide enough clamping strength,which leads to vibration or fly off when the blade handle is upset.:
Never assume that the new is safe and reliable.When odd contact marks or grooves are found in the handle part after clamping,slip situation and inner hole deformation of the clamp should be replaced immediately to avoid accidents.:
When the cutter is installed and clamped,stop the machine immediately if it is ground that the knife has a fluttering phenomenon when working. Repeat the clamping for several times so that the tool handle and the clamping sleeve are in full contact and the work is carried out.:
The tool handle should be in good contact with the clamping sleeve,and the tool handle must be fully inserted into the clamping sleeve and tightened firmly,so as to provide sufficient clamping force for the tool.A small part should not only be inserted into the sleeve,differently it may cause breakage of the shank and damage to the cutter.:
Conquer research and ear p :

Mais produtos na categoria